Korg Monotron Repair Mod

Posted by Quinn Madson | Posted in | Posted on 2:33 PM

1

Due to a series of unfortunate events, the surface mounted 1/8 jack was torn off of the board of this Korg Monotron analog synth. I decided to try and tie into the existing onboard speaker to allow the synth to still connect to external speakers or mixer. 

I drilled a small hole on the left side to allow wires into the enclosure.
I noted the wires so that if pulled, the solder joints won't be stressed.

I ran the new line-out red line into the existing solder joint for the onboard speaker.

I desoldered the black line to the onboard speaker. I made a joint between the new line-out black line, the  speaker black line, and a new jumper.

All soldered together and bit of heat shrink.
Connected the switch (momentary - normally off) to the original speaker black line solder joint and to the jumper from above.
All put together with the switch mounted and a lesbian adapter on the 1/8 inch male plug end.


Here is a video of the synth put back together and operating. First part of the video (~20 secs) is demoing the momentary switch activating the onboard speaker. The rest is using an external speaker system.




Comments (1)

I would like to thank you for the efforts you have made in writing this article. I am hoping the same best work from you in the future as well. Your write up is a fine example of it.
iPhone Repair Dallas